Tel: +86-371-60301018
Fax: +86-371-60301019
E-mail: dctec@ink4you.com
Address: No. 10, Yulan West Street, High-Tech Zone, Zhengzhou, Henan, China 450000
Preparation:Dismantling and installation of the original chip .As show below, removing the lip of the original ink cartridge,Removing the Cover, As shown below, put the original chip into printer.....
In this instruction, the printer is a new Epson 9880 and the cartridges are Hongsam compatible cartridge for Epson 7880/9880 with 220ml K3 VM pigment ink.As the chip on the compatible cartridge.
Equipments Required:A set of 700ml refillable cartridges for Canon iPF 8000/9000, 8100/9100, 8000S/9000S Hongsam pigment ink for Canon iPF series.There are four parts of the 700ml refillable cartridge: cartridge body, seal, cartridge clip and cap.
1. Mix proportion: HOTMEMATE-A :HOTMEMATE-B = 2 : 12. Mix A with B according to the need and blend well.3. How to do:(1) Spray the mixed coating over the solid material’s surface with a brush or spray gun;
How to Disable Ink Level Detection.When the ink is run out, information will display like the following picture.Open the cover of corresponding cartridge, remove the cartridge and refill it. Then install it.
Equipments Required. One piece of Syringe with pinhead, 60ml preferred One roll of double-adhesive tape One paper knife 0.5kg ion-free water One set of transparent cartridges.....
I. ApplicationThis high effective cleaning lotion is for the maintaining and clearing of printer heads using dye ink. The successful rate is 70%-80%. It is environmental friendly.II. Instruc
1) Turn off the printer, press the key of "Paper Source" and "Information" at the same time, then press the key of "power".2) Stop pressing until "Initializing"
I. Preparation before Refilling1. There are three parts taking part in refilling:1000ml bottle ink, refilling kit and empty original cartridge to be filled2. Notices:(1) Clean the refilling kit with i
I. Install the firmware updating software LPrinterServiceTool_ENU_V1.2.1 in the computerII. Connect the USB with the printer.III. Operate L PrinterServiceTool,press “Refresh” to search for